Any mechanic or automotive enthusiast can tell you that an engine is essentially a large air pump. The more an engine can suck in air to mix with fuel, the more it can create power through combustion. Thus, the more efficiently an engine removes exhaust gases from the cylinders, the better it can manage that power. The key to a strong, healthy engine is adequate air from one end to another.

Air flow is affected by many different components in the motor, but the valves in the cylinder head are what directly control the amount of air entering a cylinder, and the volume of exhaust gases leaving it. The intake valves open up just prior to combustion in order to allow air to flow in and mix with fuel, and the exhaust valves open after the ignition of this mixture in order to suck out the resulting gases. The timing of the valves is controlled by a rotating shaft called the camshaft. The camshaft has lobes which push up on the valves in order to open them and drop them back closed again.

An engine’s drivability and power can really be affected by length of time and the point in the combustion cycle at which the valves are open. A really fast car, such as a race car, will need an engine that produces lots of power at high RPMs. To get this, the camshaft can be adjusted to perform well at higher RPMs, but the trade-off will be poor performance at low RPMs. Following the same principle, adjusting the camshaft to perform best at low RPMs will give you lots of low-end torque, which is great for jobs like towing, but your high RPM performance will suffer.

Unfortunately, street vehicles are a compromise between reliability, fuel efficiency and power. While race vehicles have engines with camshaft designs that generate large amounts of power while being used only at specific, high revolutions, your daily driver sees a wide range of RPMs that make a broader power band necessary. While it is ok for a race car to have a lumpy idle that barely runs below 1000 rpm, it would do you no good if your street car stalled out at every stoplight. Regular vehicles usually have to make do with a camshaft that provides a good amount of power in the most often used range of engine RPMs, but runs out of steam at high speeds.

These types of camshafts obviously aren’t too efficient. Since they’re trying to do everything adequately, they don’t really do any one of them superiorly. Your engine needs to be able to perform just as well accelerating from a stop as it does speeding down the highway, which means that much of the time, it’s burning too much fuel and also underperforming.

Automakers have developed something called “variable valve timing” (VVT) to address this problem. Toyota’s newest VVT-i engine, the Toyota Tundra’s i-Force 5.7L V8, can vary the timing of the valves to match engine speed. It uses engine oil pressure to make slight adjustments to the camshaft, so that more aggressive lobe designs are used when working at higher RPMs. This makes the i-Force capable of running a camshaft configuration which provides fuel efficiency for everyday driving, but that can still turn out lots of power when you press the pedal to the floor.

The dual VVT-i in the Tundra takes things a step further by allowing the exhaust and intake valves to open at the same time at very high RPMs in order to scavenge the airflow as much as possible. This all adds up to a V8 engine that produces 381 horsepower at 5600 rpm while still generating 401 lb-ft of torque at as low as 3600 rpm. Not only that, but in the 2 wheel drive models, the Tundra gets a respectable 20 miles per gallon on the highway. Perhaps most importantly, Toyota’s variable valve timing system lets you have killer horsepower without getting killed at the gas pump.